1、使用范围：汉普电动扭剪扳手可更换内外套筒，可用于从M12到M30的扭剪型螺栓的施工作业。

1. Scope of use: The Hanpu electric torsion shear wrench can replace the inner and outer sleeves and can be used for the construction of torsion shear bolts from M12 to M30.

开关操作：

Switch operation:

开动工具时，扣动开关柄即可，停止时松开。

When starting the tool, simply press the switch handle and release it when stopped.

注：接通工具电源插头之前，一定要检查确认开关工作是否正常，松开时能回到“关”的位置上。

Note: Before connecting the power plug of the tool, it is necessary to check and confirm whether the switch is working properly. When released, it can return to the "off" position.

紧固操作方法：

Tightening operation method:

1、将工具内套筒对正螺栓的梅花头，使梅花头插入内套筒，并完全盖住梅花头。

1. Align the inner sleeve of the tool with the plum blossom head of the bolt, insert the plum blossom head into the inner sleeve, and completely cover the plum blossom head.

注：将套筒对准螺栓梅花头时要小心，撞击梅花头时会使其损坏。以致不能正常插入套筒。

Note: Be careful when aligning the sleeve with the bolt's plum blossom head, as hitting the plum blossom head may damage it. So that it cannot be inserted into the sleeve properly.

2、对工具向前用力，使其向前滑动，直到外套筒完全盖住螺母为止。如果工具不能完全盖住螺母，请轻微的左右转动同时向前用力。

2. Apply force to the tool forward and slide it forward until the outer sleeve completely covers the nut. If the tool cannot fully cover the nut, please turn it slightly left and right while applying force forward.

3、扣动电动扳手开关，外套筒将旋转，开始拧紧螺母。当达到设定的例句力矩时，螺栓梅花头将在有V型口处被剪断。螺栓梅花头将留在内套筒里。

3. Turn on the electric wrench switch, the outer sleeve will rotate, and start tightening the nut. When the set torque is reached, the bolt plum blossom head will be cut at the V-shaped opening. The bolt plum blossom head will remain in the inner sleeve.

4、松动开关，沿着垂直方向撤下工具。‘

4. Loosen the switch and remove the tool vertically‘

5、扣下推顶器扳机，竟螺栓梅花头从工具中顶出，拿好

5. Pulling off the trigger of the pusher, the bolt's plum blossom head was pushed out of the tool, and it was taken out