服务热线: 400-117-8816
           13406879330

扭剪扳手,扭剪螺栓专用扳手,扭剪电动扳手,扭剪枪生产厂家

当前位置:首页>新闻中心定扭矩电动扳手操作注意事项

定扭矩电动扳手操作注意事项

来源:https://www.xjnwz.com日期:2024-08-01 发布人:创始人

1、螺栓直径的大小对控制精度有一定的影响,施工中应用相同型号的螺栓连接付来标定扭矩值,而且使用一段时间后还应进行检验校定。

1. The size of the bolt diameter has a certain impact on the control accuracy. During construction, the same type of bolt connection should be used to calibrate the torque value, and after a period of use, it should also be inspected and calibrated.

2、工作前应开机空转3-5分钟。操作中如发现电机火花大,声音异常,扭矩不稳定时,应立即停机检查,切勿带病工作。

2. Before starting work, the machine should be turned on and idle for 3-5 minutes. If there is a large spark, abnormal sound, or unstable torque in the motor during operation, the machine should be stopped immediately for inspection. Do not work with a problem.

ee09c096-cfe0-4912-84df-ecc22a8bf12b

3、定期清洗和更换油脂,一般在工作5000次后,应进行一次清洗加油,以延长使用寿命。

3. Regularly clean and replace grease. Generally, after 5000 operations, a cleaning and oiling should be carried out to extend the service life.

4、主机上的电源开关,碳刷,控制仪上的保险丝等均属易损件,容易引起故障,应经常检查,及时更换。

4. The power switch, carbon brush, and fuse on the controller on the host are all vulnerable parts that can easily cause malfunctions. They should be checked regularly and replaced in a timely manner.

5、使用中如发现工具上的螺钉松动,应及时紧固。

5. If the screws on the tool are found to be loose during use, they should be tightened in a timely manner.

6、搬运工具时不可提拉电缆线,并注意轻拿轻放,防止震动和摔碰。不用时应放在通风干燥处。如发现受潮应及时进行干燥处理。不可与酸、碱等有害物质气体接触或存放在一起。

6. When transporting tools, do not lift the cables and handle them gently to prevent vibration and impact. When not in use, it should be placed in a ventilated and dry place. If moisture is found, it should be dried in a timely manner. Do not come into contact with or store together with harmful substances such as acids, alkalis, etc.